Copyright © 2019 Shenzhen Kingnet Electronics Co.,LTD All rights reserved 粤ICP备16030853号 Powered by 300.cn
Products
About Us
Solution
Tel: 86-0755-36983790
code: 518108
Business: 15071373730
Technical support: 4006008058
Complaint call:18124028735
Address: 4F, Building A, Hongfa Science and Technology Park, Tangtou Community, Shiyan, Baoan District, Shenzhen
QR code
Hot event
Contact Us
FAQ
The camera will be stuck in the bridge.
In this case, there are many environmental problems, the obstacles are blocked, the directions between the two bridges are crossed, the wireless interference in the vicinity is large, the aging of the network cable is aging, and the transmission power of the bridge is too large, resulting in a large delay.
Solution:
1. Check if there are obstacles blocking between the bridges
2. Try to ensure that the two bridges are vertically and horizontally installed, horizontally and horizontally, and not cross-mounted.
3. There are many pairs of bridges in the installed environment, and the interference is large. It is recommended to isolate more than 2 meters between the bridges, and debug different channels to avoid mutual interference. (The bridge of the dialing code can press the digital key to debug the channel. Such as: digital 0 corresponds to channel 1, digital 1 corresponds to channel 2, and so on)
4. Replace the network cable. The aging network cable may cause data transmission.
5. One-to-one or one-to-many bridges are close to each other, and there is no abnormality in the long distance. The wireless power of the main bridge can be debugged. The default is 100%, and it can be changed to 50% or 75%.