Register

标题

Home

Solution

Products

Activity

About Us

Contact Us

Copyright © 2019 Shenzhen Kingnet Electronics Co.,LTD All rights reserved 粤ICP备16030853号   Powered by 300.cn

Products

About Us

Solution

Tel: 86-0755-36983790
code: 518108
Business: 15071373730
Technical support: 4006008058

Complaint call：18124028735
Address: 4F, Building A, Hongfa Science and Technology Park, Tangtou Community, Shiyan, Baoan District, Shenzhen

QR code

Hot event

Contact Us

FAQ

Home page
>
Wireless bridge

Wireless AP

Wireless bridge

Gateway routing

Switch

Q

NVR can't find IPC

Classification:
Wireless bridge
A
There is no camera scanned in the recorder add-on device, you can check it from the following aspects:
1. Confirm whether the IPC and the NVR are on the same network segment.
Q

Multiple sets of bridges placed side by side environment considerations

Classification:
Wireless bridge
A
The wireless bridge is mainly used for outdoor long-distance data transmission, and meets the needs of office building intercommunication and remote video surveillance. In some environments, multiple pairs of bridges are required, and multiple bridges on the server side need to be placed side by side.
Q

The camera will be stuck in the bridge.

Classification:
Wireless bridge
A
In this case, there are many environmental problems, the obstacles are blocked, the directions between the two bridges are crossed, the wireless interference in the vicinity is large, the aging of the network cable is aging, and the transmission power of the bridge is too large, resulting in a large delay.
Q

The bridge is connected to the camera, and the video disk does not show the lens.

Classification:
Wireless bridge
A
Usually, the bridge and the video disk are connected to the switch at the same time. The video disk does not show the lens. The bridge may not be paired or the bridge is not in the same network segment as the video disk.
Q

The amount of camera under the bridge

Classification:
Wireless bridge
A
The belt capacity of the bridge is specifically to see the actual environment to achieve the capacity. The following figure is the theoretical belt capacity, which can be used as a reference:
Page up
1
2